hit2424

Hello tankers,
This video goes through the process of changing your gearboxes on your Tiger 1 tank and some tips I have acquired on the way. Even though this is a Tiger 1 tank, once the upper hull and tracks are off the process is the same for all of the tanks.
Start by removing the tracks, we have another video here on that: http://youtu.be/fXHCUuf3SJ8?list=PLu3...
Then remove the hub cap (if applicable).
Next unscrew the 2.5/3.0mm hex screw from the drive wheel.
At this point you should be able to remove the drive wheel off of the gearbox shaft. If you cannot, please follow my tip in the video on how to remove the drive wheel safely without causing harm or damage.
Next unscrew your gear boxes from the lower chassis.
You can now remove the gearboxes from the tank.

Hello tankers!
Today we install (not setup) a IBU2 board in our Taigen Tiger 1 tank. It is plug and play, but some simple settings may need to be tweaked to get the results you wish. Later I will make another video showing this, but for now please enjoy the very simple install video.

Here is the Sturmgeschutz III (aka the Stug 3) plastic version with the new paint job from Taigen tanks! The item can be located on our website here: http://www.taigentanks.com/new-blog/2...

Hey tankers,
Today we will do a quick airsoft swap. This video is for those who have issues with firing, but still hear the motor spinning in the firing units. 95%+ of the time the swap can be performed without soldering in a new motor. Only if you apply DC current to the motor direct and nothing happens do you have to solder the new motor in. Otherwise you can just swap the plastic casing around the motor. Without me blabbing away it should only take around 5-10 minutes to do.

Hey tankers! Ok so as of today our newest tank is the Sherman M4A3 75mm tank. This guy is a beast! Check it out on our site here: http://www.taigentanks.com/new-blog/2...